ENEN
13
4. FIRST START-UP
c. Select the input used for each electrical
power.
The column on the left shows the electrical powers that can be
measured, while the top row shows the available inputs:
Pliers
of the Febos-Energy
Energy meter pulse counter
Febos-Energy
HP SMART/MT
*
Power exchange if TAE2 configured, otherwise power con-
sumed by the residence
Power consumed by the socket
Power consumed by Eco Hot Water
Power produced by the photovoltaic
Power consumed by MIRAI-SMI
* SMART-MT input configuration is linked
to the system recipe
NOTE: If an electrical power is not managed (e.g. photovoltaic not
installed) press its icon (e.g. “
") to deselect it.
4.3 Setting inputs of the electrical powers
For the correct measurement of electrical powers
it is essential to associate to each power, the relative
input.
a. Press the icon
then
b. Press
SERVICE
To Next Page
Loading...
Need help?
General