Specifications
9970002204, REV E, 4/16/2012 © 2011 EMP 12
If CAN or Serial TTL control is not used the 6 pin DTM connector must be blocked off to prevent
entry of water or dirt which will result in damage to the pump. A block off plug EMP P/N 3250001030
can be purchased or one can be fabricated from the Deutsch parts listed in the table
Figure 3 On/Off Wire harness p/n 1370005038
Figure 4: Wiring Schematic
Insert into empty cavity
of pump controller
Connect to pump
controller
LPE Rev A, 2-May-2013
To Next Page
Loading...
