EMP E2512A - Plumbing

Installation
9970002204, REV E, 4/16/2012 © 2011 EMP 15
Plumbing
CAUTION:
(!

Figure 5: Pump plumbing.
Plumbing Requirements
Pump inlet must be free from restrictions and blockages to prevent
cavitation.
Pump Inlet must be plumbed using 1.0”Dia. hose or thin walled tubing.
• Up to 1” length of 0.75” dia is permissible
Deviations from this requirement must be approved by EMP
• Please contact EMP customer service for application
review
• Warranty is void
without application approval
Inlet
Outlet
LPE Rev A, 2-May-2013