9. Unloading the Empire AXE
Warning: Always keep your Empire AXE pointed in a safe direction and always keep your
protective eye, face and ear wear on until marker is completely unloaded and safe.
• Be sure your nger is away from the trigger area.
• Place the barrel-blocking device in/on the end of the barrel.
• Turn the Empire AXE off by pressing and holding the power button. The LED will
turn from green to red. Observe the LED to make sure it is no longer lit.
• Flip the regulators on/off arm forward so it’s facing the front of the marker; allow
the air to vent and remove your air cylinder by unscrewing it counter-clockwise.
• If you are using an electronic loader make sure loader is completely turned off.
• Slightly tilt the marker so that the loader is lower than the body.
• Remove the loader by undoing the clamp and spinning it in a clockwise direction
and gently lifting it.
• Read the pressure gauge and make sure the pressure reads 0 psi.
• Do not look down the barrel but look down the feed neck to make sure there are no
paintballs in the breech.
• Remove the barrel from the marker.
• Make sure there are no more paintballs remaining in the barrel.
• Your marker is now ready to be stored in its box or marker case until its next use.
10. Regulator and Velocity Adjustment
The Empire AXE utilizes a bottom-line regulator that doubles as an on/off ASA adapter and
regulator for a standard threaded pre-set output compressed air systems or remote hose.
This unique regulator system channels air through the air transfer tube, eliminating the
need for external macro line and fittings. The Empire AXE bottom-line regulator controls
the amount of air pressure going from your compressed air system into the marker.
The Empire AXE regulator should be factory pre-set at about 190 psi, as this is the best
operating pressure for proper marker operation. However, if over time you do need to adjust
the pressure, use the regulator adjuster screw on the front of your Empire AXE bottom-line
regulator.
Regulator Adjustment
If adjustments are needed use a 3/16” Allen wrench and insert it into the regulator adjust-
ment screw. This is located in the front of the regulator; see (Fig. 10.1).
• To increase output pressure — Turn the regulator adjustment screw clockwise.
• To decrease output pressure— Turn the regulator adjustment screw
counter-clockwise.
Notes:
• Always watch the gauge as you are adjusting the pressure.
• The bottom-line regulator should not be disassembLED.
• Never set the regulator above 200 psi.
(Fig. 10.1)
To Next Page
Loading...
