To Next Page

To Previous Page

Double click on the output eld. The display will change to show the device’s output properties.

Ensure all elds are un-selected and that a delay is not present.

Also ensure the zone setting for the output (Wireless RIM) corresponds with the zone that is to

cause the device to operate. An example with the correct settings to follow zone 1 operation is

shown below:

Note: the zone setting for the device (Wireless RIM) is only relevant for the cause and eect

when programming the unit to follow the activation of a zone of devices.

Other manuals for EMS FIRECELL

Questions and Answers:

Need help?

Do you have a question about the EMS FIRECELL and is the answer not in the manual?

General