To Next Page

To Previous Page

Introduction

The FireCell Wireless Remote Indicator Module (RIM) is compatible with both the EMS FireCell

system and the EMS Fusion Loop Module.

It is possible to add (log on) the RIM to the FireCell system both manually and via FireCell

Conguration Tool software, whilst the RIM must be added to the Fusion Loop Module manually.

All of the aforementioned methods are detailed in this programming guide.

Also covered within this guide is the adding (logging on) of RIMs to the FireCell control panel, via

the Loop Explorer computer software plus two methods of programming the cause and eect

rules to link either, a zone of devices, or a single device to a RIM.

This guide has been written for engineers that have completed FireCell product training and

therefore have knowledge of the product and the basic programming functionality of the control

panel.

It is therefore assumed that the engineer is practised in the methodology of removing, editing

and sending Loop Explorer setup les to the FireCell control panel.

Note: screenshots shown in this programming guide depict FireCell Conguration Tool

version 60082 and Loop Explorer Version 3.0. Future software releases may vary both

visually and in operation.

Tools

Before starting the programming, the following items MUST be available.

Laptop c/w Loop Explorer software

FireCell control panel programming lead (FC-000-KEN)

Other manuals for EMS FIRECELL

Questions and Answers:

Need help?

Do you have a question about the EMS FIRECELL and is the answer not in the manual?

General