EL – Owner’s Manual – Rev.00 – September 2022 49
Before transport, verify that the device completely cooled down and that the electrolyte tank has been
emptied according to Appendix III. Seal the connections on the front panel by inserting the red plugs
that were supplied with the device into their respective bulkheads and place the plastic caps on the
hydrogen outlet and vent lines. Ensure the device is transported in an upright position, and that an
indicator for this is clearly visible on the outside of the packaging.
Attention!
Enapter may not accept the device if returned without the original shipping boxes or
equivalent for safe transport. If damage occurs during the return of a device under
warranty, Enapter will not cover the costs of repair.
Warning!
Never lift a device alone, as it weighs over 40 kg. Use lifting aids if available.
Due to their weight and size, it is recommended to use a pallet cart or similar devices to
manoeuvre the box upon delivery. If the box must be lifted, always lift it with at least
two persons.
Attention!
During winter, or when outside conditions are below freezing temperature as well as for
very hot environments, the shipping box must be additionally marked with a label
informing the shipping agent that the package may not be exposed to temperatures
outside of the given storage temperatures stated in the datasheet.
To Next Page
Loading...
