Enapter Electrolyser 4.0 - 1.2 Front Panel & Bottom

VERSION
DOCUMENT TITLE
RELEASE DATE
00
EL 4.0 – Owner’s Manual
2022-09-12
EL – Owner’s Manual – Rev.00 – September 2022 4
1.2 FRONT PANEL & BOTTOM
EL4.0 AC air cooled front side
EL4.0 DC liquid cooled front side
EL4.0 air cooled bottom view
The front panel includes most of the physical connections of the device. The leakage drain hole is
positioned on the bottom of the device. For more information please refer to the battery limits.
1. H
2
O IN – please refer to the section Water Inlet Connection Guide (H2O IN)
 Push-fit female bulkhead connector (10 mm outer diameter pipes) LLDPE
 Input: Filtered water input with a conductivity < 20 µS/cm at 25°C, input pressure
between 1 and 4 bar
2. O
2
VENT – please refer to the Oxygen Vent Connection Guide (O2 VENT)
 ⅜" bspp female port