ENHWI-3GN3 User’s Manual
www.encore-usa.com
57
• WPS Tab - Push Button Wireless Connection
Push Button Wireless Connection is the simplest way to establish a connection
between the wireless clients and the wireless router. You don’t have to select the
encryption mode and fill in a long encryption passphrase every time when you try
to setup a wireless connection. You only need to press a button on both wireless
client and wireless router, and the WPS will do the rest for you.
The wireless router supports two types of Push Button Wireless Connection, the
Push Button and PIN code. If you want to use the Push Button, you have to push
a specific button on the wireless client or in the utility of the wireless client to start
the Push Button Wireless Connection mode, and switch the wireless router to
Push Button Wireless Connection mode. You can simply push the push button of
the wireless router, or click the ‘Start to Process’ button in the web configuration
interface. If you want to use the PIN code, you have to know the PIN code of the
wireless client and switch it to Push Button Wireless Connection mode, then fill-in
the PIN code of the wireless client through the web configuration interface of the
wireless router.
WPS: (Push Button Wireless Connection)
Check the box to enable WPS function and uncheck it to disable the WPS
function.
WPS Current Status:
If the wireless security (encryption) function of this wireless router is properly set,
you’ll see a ‘Configured’ message here. Otherwise, you’ll see ‘UnConfigured’.
Click the “Release Configuration” can clear the security settings of the 1
st
SSID.
Self Pin Code:
This is the Push Button Wireless Connection PIN code of the wireless router.
You may need this information when connecting to other WPS-enabled wireless
devices.
To Next Page
Loading...
Need help?
General
