ENHWI-3GN3 User’s Manual
www.encore-usa.com
83
• LAN Tab:
The LAN Tabs shows LAN settings. LAN settings can be change as needed. If you
are an entry level user, try opening a website from your computer. If you’re
successful and able to connect and browse the web site you opened without any
problem, do not change any of the settings.
Click <Apply> at the bottom of this screen to save the changed configurations.
IP address: This is the router’s LAN IP address (Your LAN clients default gateway
IP address). It can be changed based on your network architecture.
IP Subnet Mask: Specify a Subnet Mask IP address for your LAN segment.
802.1d Spanning Tree: This is disabled by default. If 802.1d Spanning Tree
function is enabled, this router will use the spanning
tree protocol to prevent network loops.
To Next Page
Loading...
