Endress+Hauser Analytik Jena TOPwave - Selecting Setup Parameters

Installation and Setup TOPwave
24
Note:
Pressing the [
LOGGED IN AS...] key in the Main menu allows to enter login window again
to change login status.
User rights User Master Service
Change user program No yes yes
Change pre-installed applications No no yes
Change type of vessels in program Yes yes yes
Open Setup menu No yes yes
Open Service menu No no yes
Change User Code No yes yes
Change Master Code no No yes yes
Change Service Code No no no
 Open the lid by pressing the [O
PEN] key on the Main menu.
 A clearly audible clicking is heard and unlocking is indicated on the screen.
 Then open the lid with the red handle. The lid then swings to the right to its end
stop.
 After 10 seconds the lid is automatically locked again. In this case, again press [
O-
PEN
].
 The rotor for the pressure vessels is preassembled on delivery. Remove the pressure
vessels and insert the empty rotor into the microwave oven. By gently turning the ro-
tor on the axis, find the position at which the rotor again engages downwards.
 The rotor is now correctly positioned in the micro-wave oven.
 The opening station for CX 100 pressure vessels can be secured in an exhaust hood /
vent unit by means of the adhesives strips on its underside.
5.2.1 Selecting Setup Parameters
 Press [SETUP] in MAIN menu window.
Note: Only the user with M
ASTER login can open the SETUP menu.
The following parameters can be selected:
Turntable installation
Accessories