EasyManua.ls Logo

Endress+Hauser Cerabar PMP11 - User Manual

Endress+Hauser Cerabar PMP11
48 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Products Solutions Services
Operating Instructions
Cerabar PMC11, PMC21, PMP11,
PMP21, PMP23
Process pressure measurement
Pressure transducer for safe measurement and
monitoring of absolute and gauge pressure
BA01271P/00/EN/05.17
71353696

Table of Contents

Other manuals for Endress+Hauser Cerabar PMP11

Preview: Technical Information
Technical Information52 pages

Questions and Answers

  • D
    David JohnsonAug 12, 2025
    What to do if my Endress+Hauser Switch is not responding?
    • T
      Troy SingletonAug 12, 2025
      If your Endress+Hauser Switch is not responding, there might be a few reasons: * The supply voltage may not match the specifications on the nameplate. Ensure you apply the correct voltage. * The supply voltage polarity could be incorrect. Try reversing the polarity of the supply voltage. * The connecting cables might not be making proper contact with the terminals. Inspect the cable connections and correct them if needed.
  • J
    John HaleyAug 20, 2025
    Why is the output current of my Endress+Hauser Switch less than 3.6 mA?
    • D
      David ScottAug 20, 2025
      If the output current of your Endress+Hauser Switch is less than 3.6 mA, the signal line may not be wired correctly. In this case, you should check the wiring.
  • T
    Timothy SpencerSep 1, 2025
    What to do if Endress+Hauser Industrial Equipment is not responding?
    • G
      garciaaprilSep 1, 2025
      If your Endress+Hauser Industrial Equipment is not responding, ensure that the supply voltage matches the specifications on the nameplate. If it doesn't, apply the correct voltage. Also, verify that the supply voltage polarity is correct; reverse it if necessary. Finally, check that all connecting cables are securely in contact with the terminals and correct any issues.

Endress+Hauser Cerabar PMP11 Specifications

General IconGeneral
TypeCerabar PMP11
Device TypePressure transmitter
Measured VariablePressure
Measuring PrinciplePiezoresistive
Output Signal4 to 20 mA
Power Supply10 to 30 VDC
Housing MaterialStainless steel
Wetted Parts MaterialStainless steel
Process ConnectionG1/2 or 1/2 NPT
Operating Temperature-40 to 85 °C
ApprovalsATEX, IECEx
Accuracy±0.5% of span

Related product manuals