Endress+Hauser Cerabar S PMP71 User Manual (English)

Other manuals for Endress+Hauser Cerabar S PMP71

Operating Instructions238 pages

Manual96 pages

Assembly8 pages

Functional Safety Manual48 pages

Technical Information136 pages

Installation Instructions8 pages

Questions and Answers:

R
robert13Jul 26, 2025
What to do if my Endress+Hauser Cerabar S PMP71 Measuring Instruments device is not responding?
- S
  srussellJul 26, 2025
  If your Endress+Hauser Measuring Instruments device is not responding, consider these potential causes and solutions: * The supply voltage might not match the specifications on the nameplate. If this is the case, apply the correct voltage. * The supply voltage might have incorrect polarity. If so, reverse the polarity of the supply voltage. * There might be no contact between the connecting cables and terminals. Check the contacting of the cables and correct if necessary.
Z
zachary42Aug 5, 2025
Why is there no display on my Endress+Hauser Measuring Instruments?
- E
  Eric BlackwellAug 5, 2025
  If there is no display on your Endress+Hauser Measuring Instruments, it could be due to several reasons: 1. The onsite display might be set too bright or too dark. To fix this, set the local display brighter by simultaneously pressing O and F, or set it darker by simultaneously pressing S and F. 2. The connector for the local display might not be plugged in correctly. Ensure the connector is properly plugged in. 3. The onsite display might be defective. If this is the case, replace the onsite display.
S
Scott GreeneAug 14, 2025
Why is my Endress+Hauser Measuring Instruments Alarm Status not displaying the expected message priorities?
- J
  Joseph MartinezAug 15, 2025
  The Alarm Status/ALARM_STATUS parameter in Endress+Hauser Measuring Instruments shows the message with the highest priority. Check if the expected message has the highest priority.

Endress+Hauser Cerabar S PMP71 Specifications

General

Device Type	Pressure Transmitter
Manufacturer	Endress+Hauser
Model	PMP71
Measurement Principle	Piezoresistive
Measured variable	Pressure
Process Pressure	Up to 400 bar
Communication Protocol	HART
Diaphragm material	Stainless Steel
Material	Stainless Steel
SIL suitability	SIL 2
Type	Pressure transmitter
Series	Cerabar
Process Temperature	-40 to 125 °C
Output Signal	4 to 20 mA
Protection Class	IP66/IP67
Process connection	Thread, Flange
Approvals	ATEX, IECEx