Endress+Hauser Cerabar S PMP72 User Manual (English)

Other manuals for Endress+Hauser Cerabar S PMP72

Operating Instructions238 pages

Manual96 pages

Functional Safety Manual48 pages

Installation Instructions8 pages

Technical Information136 pages

Questions and Answers:

A
Alyssa SmithAug 11, 2025
What to do if my Endress+Hauser Cerabar S PMP72 device is not responding?
- M
  Michael MartinezAug 11, 2025
  If your Endress+Hauser Measuring Instruments device is not responding, consider these potential causes and solutions: * The supply voltage might not match the specifications on the nameplate. If this is the case, apply the correct voltage. * The supply voltage might have incorrect polarity. If so, reverse the polarity of the supply voltage. * There might be no contact between the connecting cables and terminals. Check the contacting of the cables and correct if necessary.
M
Michelle MurphyAug 21, 2025
Why is there no display on my Endress+Hauser Measuring Instruments?
- E
  Emily ThompsonAug 21, 2025
  If there is no display on your Endress+Hauser Measuring Instruments, it could be due to several reasons: 1. The onsite display might be set too bright or too dark. To fix this, set the local display brighter by simultaneously pressing O and F, or set it darker by simultaneously pressing S and F. 2. The connector for the local display might not be plugged in correctly. Ensure the connector is properly plugged in. 3. The onsite display might be defective. If this is the case, replace the onsite display.
E
Emily FernandezAug 30, 2025
Why is my Endress+Hauser Cerabar S PMP72 Alarm Status not displaying the expected message priorities?
- D
  Dr. Christy WalkerAug 31, 2025
  The Alarm Status/ALARM_STATUS parameter in Endress+Hauser Measuring Instruments shows the message with the highest priority. Check if the expected message has the highest priority.

Endress+Hauser Cerabar S PMP72 Specifications

General

Device Type	Pressure transmitter
Manufacturer	Endress+Hauser
Series	Cerabar S
Model	PMP72
Measured variable	Pressure
Accuracy	±0.1 % of span
Housing material	Stainless steel
Protection class	IP66/IP67
Measuring range	0 ... 400 bar
Output signal	4…20mA HART
Long-term stability	±0.1% of URL per year
Operating temperature	-40°C to +85°C
Process temperature	-40 ... 125 °C
Ambient temperature	-40 to +85°C (-40 to +185°F)
Communication	HART
Sensor material	Ceramic
Approvals	ATEX, IECEx
Material	Ceramic
Power supply	10.5-45 V DC