Endress+Hauser Cerabar S PMP75 User Manual (English)

Other manuals for Endress+Hauser Cerabar S PMP75

Operating Instructions238 pages

Manual96 pages

Brief Operating Instructions36 pages

Technical Information136 pages

Installation Instructions8 pages

Questions and Answers:

R
Robin HortonAug 8, 2025
What to do if my Endress+Hauser Cerabar S PMP75 Measuring Instruments device is not responding?
- C
  carly31Aug 8, 2025
  If your Endress+Hauser Measuring Instruments device is not responding, consider these potential causes and solutions: * The supply voltage might not match the specifications on the nameplate. If this is the case, apply the correct voltage. * The supply voltage might have incorrect polarity. If so, reverse the polarity of the supply voltage. * There might be no contact between the connecting cables and terminals. Check the contacting of the cables and correct if necessary.
L
longdanielleAug 19, 2025
Why is there no display on my Endress+Hauser Cerabar S PMP75 Measuring Instruments?
- K
  Kiara KirbyAug 19, 2025
  If there is no display on your Endress+Hauser Measuring Instruments, it could be due to several reasons: 1. The onsite display might be set too bright or too dark. To fix this, set the local display brighter by simultaneously pressing O and F, or set it darker by simultaneously pressing S and F. 2. The connector for the local display might not be plugged in correctly. Ensure the connector is properly plugged in. 3. The onsite display might be defective. If this is the case, replace the onsite display.
D
Dylan StephensonAug 28, 2025
Why is my Endress+Hauser Measuring Instruments Alarm Status not displaying the expected message priorities?
- P
  Patricia FernandezAug 28, 2025
  The Alarm Status/ALARM_STATUS parameter in Endress+Hauser Measuring Instruments shows the message with the highest priority. Check if the expected message has the highest priority.

Endress+Hauser Cerabar S PMP75 Specifications

General

Device Type	Pressure transmitter
Manufacturer	Endress+Hauser
Product Family	Cerabar
Model	PMP75
Measured variable	Pressure
Measuring principle	Piezoresistive
Output signal	4 to 20 mA HART, PROFIBUS PA, FOUNDATION Fieldbus
Process Temperature	-40 to 85 °C
Ambient temperature	-40 to 85°C (-40 to +185°F)
Process connection	Thread, Flange
Housing material	Stainless steel
Material	Stainless steel
Protection class	IP67
Approvals	ATEX, CSA, IECEx
SIL compliance	SIL 2
Power Supply	10.5 to 45 V DC (depending on output signal)