Endress+Hauser Cleanfit CPA871 - Page 59

Cleanfit CPA871 Maintenance
Endress+Hauser 59
Assembly
Fit support housing and service chamber together
7
14
13
6
A0030343
 39 Assembling the support housing
6 Service chamber
7 Support housing
13 Positioning pin
14 Positioning groove
1. Place the support housing (item 7) on a level surface.
 The positioning groove (item 14) is visible from above.
2. Place the service chamber (item 6) on the support housing.
3. Slide the service chamber into the support housing.
4. Place the positioning pin (item 13) over the corresponding groove.
5. Push the service chamber into the groove.
6. Mount the process connection on the support housing.
7. Tighten the securing screws with a torque of 4 Nm.