Endress+Hauser Cleanfit CPA871 - Accessories

Accessories Cleanfit CPA871
72 Endress+Hauser
10 Accessories
The following are the most important accessories available at the time this documentation
was issued.
‣
For accessories not listed here, please contact your Service or Sales Center.
The following accessories can be ordered via the product structure or the spare parts structure
XPC0001:
• Weld-in adapter G1¼, straight, 35 mm, 1.4435 (AISI 316 L), safety nozzle
• Weld-in adapter G1¼, angled, 35 mm, 1.4435 (AISI 316 L), safety nozzle
G 1¼
12
Ø 42
Ø 25
Ø 25
12
Ø 42
G 1¼
15°
35 (1.38)
(1.65)
(0.98)
(0.47)
(1.65)
(0.98)
(0.47)
35 (1.38)
20
(0.79)
23.5
(0.93)
35
(1.38)
20
(0.79)
23.5
(0.93)
35
(1.38)
A0028744
 49 Weld-in adapter (safety nozzle), dimensions in mm (inch)
• Dummy plug G1¼, 1.4435 (AISI 316 L), FPM - FDA
• Sensor dummy 120 mm, 1.4435 (AISI 316 L), Ra = 0.38 µm
• Sensor dummy 225 mm, 1.4435 (AISI 316 L), Ra = 0.38 µm
• Sensor dummy 360 mm, 1.4435 (AISI 316 L), Ra = 0.38 µm
• Kit, seals for non-wetted parts
• Kit, FKM seals, G1¼, wetted parts
• Kit, FKM seals, immersion chamber version, wetted parts
• Kit, seal, wetted, EPDM
• Kit, seal, wetted, FKM
• Kit, seal, FFKM, basic, wetted
• Cable, plug-in, limit switch, M12, 5 m
• Cable, plug-in, limit switch, M12, 10 m