Endress+Hauser Cleanfit CPA871 - Connections; Installation Material for Rinse; Mounting; Technical Data

Technical data Cleanfit CPA871
80 Endress+Hauser
10.3 Installation material for rinse connections
Kit, water filter
• Water filter (dirt trap) 100 µm, complete, incl. angle bracket
• Order No. 71390988
Pressure reducer kit
• Complete, incl. manometer and angle bracket
• Order No. 71390993
Hose connection set G¼, DN 12
• 1.4404 (AISI 316L) 2 x
• Order No. 51502808
Hose connection set G¼, DN 12
• PVDF (2 x)
• Order No. 50090491
11 Technical data
11.1 Mounting
11.1.1 Sensor selection
Depending on the assembly version.
Short version
Gel sensors, ISFET 120 mm
Gel sensors, ISFET 225 mm
KCl sensors 225 mm
Long version Gel sensors, ISFET 225 mm
Gel sensors, ISFET 360 mm
Immersion chamber
version (short)
Gel sensors, ISFET 225 mm
KCl sensors 360 mm
Immersion chamber
version (long)
Gel+KCl 360 mm
11.1.2 Special mounting instructions
Limit position switches
Switching element function:
NAMUR NC contact (inductive)
Switching distance: 1.5 mm (0.06 ")
Nominal voltage: 8 V
Switching frequency: 0 to 5000 Hz
Housing material: Stainless steel