Repair Cleanfit CPA871
70 Endress+Hauser
9 Repair
9.1 General notes
The repair and conversion concept provides for the following:
• The product has a modular design
• Spare parts are grouped into kits which include the associated kit instructions
• Only use original spare parts from the manufacturer
• Repairs are carried out by the manufacturer's Service Department or by trained users
• Certified devices can only be converted to other certified device versions by the
manufacturer's Service Department or at the factory
• Observe applicable standards, national regulations, Ex documentation (XA) and certificates
1. Carry out the repair according to the kit instructions.
2. Document the repair and conversion and enter, or have entered, in the Life Cycle
Management tool (W@M).
L
WARNING
Danger resulting from improper repair!
‣
Any damage to the assembly that compromises pressure safety must be repaired only by
authorized and qualified personnel.
‣
Damage to the drive can be repaired only at the place of manufacture. Repairs cannot be
carried out onsite.
‣
Following each repair and maintenance task, check the assembly for leaks using
appropriate procedures. Following this, the assembly must again comply with the
specifications in the technical data.
‣
Replace all other damaged components immediately.
‣
Following repairs, check that the device is complete, in a safe condition and functioning
correctly.
9.2 Spare parts
Device spare parts that are currently available for delivery can be found on the website:
www.endress.com/device-viewer
‣
Quote the serial number of the device when ordering spare parts.
9.3 Return
The product must be returned if repairs or a factory calibration are required, or if the wrong
product was ordered or delivered. As an ISO-certified company and also due to legal
regulations, Endress+Hauser is obliged to follow certain procedures when handling any
returned products that have been in contact with medium.
To Next Page
Loading...