What to do if sensor calibration is canceled on Endress+Hauser CM14-AAK?
If the sensor calibration is canceled on your Endress+Hauser Transmitter, check the sensor and replace it if required due to it being overaged. Also, check the buffer to ensure it is not temporarily dry or has a non-constant value.
How to fix no calibration data present error on Endress+Hauser CM14-AAK Transmitter?
If there is no calibration data present on your Endress+Hauser Transmitter, carry out airset calibration.
How to troubleshoot no measured value displayed on Endress+Hauser CM14-AAK Transmitter?
If there is no measured value displayed on your Endress+Hauser Transmitter, first check the power supply to the device. If the power is supplied and the issue persists, the device may be defective and require replacement.
What to do if there is no sensor communication with Endress+Hauser CM14-AAK?
If your Endress+Hauser Transmitter is showing no sensor communication, you should: * Check the sensor cable connection. * Check the sensor cable for a short-circuit. If these steps don't resolve the issue, the sensor may need to be replaced. If the issue persists after replacing the sensor, or if the sensor firmware update was canceled with an error, contact service.
Why is the sensor data invalid on my Endress+Hauser CM14-AAK Transmitter?
If you are experiencing invalid sensor data with your Endress+Hauser Transmitter, try updating the date of the transmitter. If the issue continues, the sensor may need to be replaced.
How to fix no conductivity display on Endress+Hauser CM14-AAK?
If your Endress+Hauser Transmitter shows no conductivity display, first check the sensor installation to ensure it is not in the air. If the sensor is properly installed and the issue persists, the sensor may be defective and require replacement.
What to do if Endress+Hauser Transmitter is not writing data?
If the sensor data could not be written on your Endress+Hauser Transmitter, try repeating the writing of the sensor data. If the issue persists, the sensor may need to be replaced.
Why is the measured value outside the specified range on my Endress+Hauser CM14-AAK Transmitter?
If the measured value is outside the specified range on your Endress+Hauser Transmitter, consider the following: * If the sensor is in the air, increase the process value. * If there's an air cushion in the assembly, check the measuring chain. * If there's incorrect sensor inflow, change the sensor type.
How to correct sensor type error on Endress+Hauser CM14-AAK?
If your Endress+Hauser Transmitter indicates an incorrect sensor type, switch to a sensor of the configured type.
What causes poor energy supply to sensor in Endress+Hauser Transmitter?
If there's a poor energy supply to the sensor on your Endress+Hauser Transmitter, check the cable connections. If the problem persists, replace the sensor.
General| Device Type | Transmitter |
|---|---|
| Manufacturer | Endress+Hauser |
| Model | CM14-AAK |
| Protection Class | IP65 |
| Output | 4-20 mA |
| Power Supply | 12 to 30 V DC |
| Measurement Principle | Conductive |
To Next Page