CM14 Operation
Endress+Hauser 15
A0010421
• Open the configuration menu
• Confirm an entry
• Select a parameter or submenu offered in the menu
A0010422
Within the configuration menu:
• Scroll step-by-step through the parameters/menu items/characters offered
• Change the value of the selected parameter (increase or decrease)
Outside the configuration menu:
Display enabled and calculated channels, as well as min. and max. values for all the active channels.
You can always exit items/submenus at the end of the menu by selecting "x Back".
Leave the setup directly without saving the changes by pressing the ‘-’ and ‘+’ keys
simultaneously for over 3 s seconds.
5.3 Icons
5.3.1 Display icons
Hold function (→ 16) aktiv.
Max Maximum value/value of the maximum indicator of the channel displayed.
Min Minimum value/value of the minimum indicator of the channel displayed.
Error, under/over range.
No display of the measured value.
In the dot matrix section, the error and the channel name (TAG) are specified.
5.3.2 Icons in the editing mode
The following characters can be used to enter user-defined text:
‘0-9’, ‘a-z’, ‘A-Z’, ‘+’, ‘-’, ‘*’, ‘/’, ‘\’, ‘%’, ‘°’, ‘2’, ‘3’, ‘m’, ‘.’, ‘,’, ‘;’, ‘:’, ‘!’, ‘?’, ‘_’, ‘#’, ‘$’, ‘"’, ‘´’, ‘(’, ‘)’,
‘~’
For numerical entries, the numbers ‘0-9’ and the decimal point are available.
Furthermore, the following icons are used in the editing mode:
Symbol for the setup
Symbol for the Expert setup
Symbol for diagnostics
Accept entry.
If this icon is selected, the information entered is accepted at the position and the user exits the
editing mode.
Reject entry.
If this icon is selected, the information entered is rejected and the user exits the editing mode. The
text configured beforehand remains unchanged.
To Next Page
Loading...
