Need help?Do you have a question about the Endress+Hauser Liquisys M CLM223 and is the answer not in the manual?
General| Type | Transmitter |
|---|---|
| Protection Class | IP 65 |
| Relay | Optional |
| Measurement Principle | Conductivity measurement |
| Input Signal | Conductivity |
| Output Signal | 4-20 mA, HART |
| Measurement Range | 0.01 µS/cm to 2000 mS/cm |
| Display | LCD |
| Communication Protocols | HART |
| Ambient Temperature Range | -20 to 55 °C |
| Outputs | 0/4...20 mA |
Explains danger, warning, caution, notice levels and used symbols.
Requirements for personnel, designated use, and general safety compliance.
Covers operational safety, state-of-the-art, and IT security aspects.
Safety guidelines for wiring and the overall wiring diagram.
Safety checks and power-up procedure for initial commissioning.
Step-by-step guide for essential initial transmitter configuration.
Steps for calibrating the transmitter and sensors using different methods.
Guidance on resolving issues and a list of system error messages.
Identifies and resolves errors related to process conditions and device hardware.
Details input ranges, output signals, and protocol data.
To Next Page