Liquisys M CLM223/253 Incoming acceptance and product identification
Endress+Hauser 9
3 Incoming acceptance and product
identification
3.1 Incoming acceptance
1. Verify that the packaging is undamaged.
Notify your supplier of any damage to the packaging.
Keep the damaged packaging until the matter has been settled.
2. Verify that the contents are undamaged.
Notify your supplier of any damage to the delivery contents.
Keep the damaged products until the matter has been settled.
3. Check the delivery for completeness.
Check it against the delivery papers and your order.
4. Pack the product for storage and transportation in such a way that it is protected
against impact and moisture.
The original packaging offers the best protection.
The permitted ambient conditions must be observed (see "Technical data").
If you have any questions, please contact your supplier or your local sales center.
3.2 Scope of delivery
The delivery of the field device comprises:
• 1 transmitter CLM253
• 1 plug-in screw terminal, 3-pin
• 1 cable gland Pg 7
• 1 cable gland Pg 16 reduced
• 2 cable glands Pg 13.5
• 1 set of Operating Instructions
• For versions with HART communication:
1 set of Operating Instructions: Field communication with HART
• For versions with PROFIBUS interface:
1 set of Operating Instructions: Field communication with PROFIBUS PA/DP
The delivery of the panel-mounted device comprises:
• 1 transmitter CLM223
• 1 set of plug-in screw terminals
• 2 tensioning screws
• 1 set of Operating Instructions
• For versions with HART communication:
1 set of Operating Instructions: Field communication with HART
• For versions with PROFIBUS interface:
1 set of Operating Instructions: Field communication with PROFIBUS PA/DP
To Next Page
Loading...
