CM14 Commissioning
Endress+Hauser 21
The following settings can be made for each of the two limit values: assignment, limit,
hysteresis, switching behavior, delay and fault mode.
6.5 Device diagnostics (Diagnostics menu)
Press the 'E' button during operation to call up the main menu. Use the '+'- and '-' buttons to
navigate through the available menus. When the desired menu is displayed, press the 'E' key
to open the menu. Select the "x Back" option at the end of each menu/submenu to navigate
one level higher in the menu structure.
Parameter Configuration options Description
Current diag. Read only Display the current diagnostic message
Last diag. Read only Display the last diagnostic message
Diagnost logbook Read only Display the last diagnostic messages
Device info Read only Display device information
Device tag Read only View the device designation
Device name Read only Display the device name
Serial number Read only Displays the serial number of the device
Order ident Read only Displays the order code of the device
FW revision Read only Display the firmware version
ENP version Read only Display the version of the electronic type plate
Module ID Read only Display the module ID
Manufact. ID Read only Display the manufacturer's ID
Manufact. name Read only Display the manufacturer name
To Next Page
Loading...
