Operation CM14
16 Endress+Hauser
Move one position to the left.
If this icon is selected, the cursor moves one position to the left.
Delete back.
If this icon is selected, the character to the left of the cursor is deleted.
Delete all.
If this icon is selected, all the information entered is deleted.
5.4 Operating functions
The operating functions of the transmitter are organized into the following menus:
Display Adjusting the device display: contrast, brightness, switching time for displaying the measured values
Setup Device settings
For descriptions of the individual settings, refer to the chapter on Commissioning (→ 17).
Calibration Carrying out the sensor calibration
For descriptions of the calibration functions, refer to the chapter on Calibration.
Diagnostics Device information, diagnostic logbook, sensor information, simulation
5.5 Hold function
The effect of the Hold function is to "freeze" the current outputs and relay states. It can be
switched on or off manually (menu Setup→Manual hold). Furthermore, the Hold function is
automatically activated during sensor calibration.
The Hold function remains active after discontinuation of the hold condition for an adjustable
Hold-release time. The Hold-release time can be set under Setup→Extended
setup→System→Hold release.
The measured value display is not affected by the Hold function. The Hold symbol is displayed
behind the measured value.
To Next Page
Loading...
