Endress+Hauser CM14-AAK - Page 34

Technical data CM14
34 Endress+Hauser
11.2.4 Alarm output
The alarm output is designed as an "open collector." In normal operation the alarm output is
closed. In the event of a fault (F-fault, device without current) the "open collector" opens.
Current max. 200 mA
Voltage max. 30 V DC
11.3 Current outputs, active
11.3.1 Span
0 to 23 mA
11.3.2 Signal characterization
Linear
11.3.3 Electrical specification
Output voltage
Max. 24 V
11.3.4 Cable specification
Cable type
Recommendation: shielded line
Cross-section
Max. 1.5 mm² (16 AWG)
11.4 Relay outputs
11.4.1 Relay types
2 changeover contacts
11.4.2 Relay switching capacity
Max. 3 A24 V DC
Max. 3 A253 V AC
Min. 100 mW (5 V / 10 mA)
11.4.3 Cable specification
Cross-section
Max. 2.5 mm² (14 AWG)