Deltabar FMD71, FMD72 Description of device parameters
53
Write permission No write permissions. Parameter is read only.
Description Indicates which measured value is transmitted via the HART protocol as the third process
value. The process value is configured via HART command 51.
Factory setting • "Pressure" measuring mode: "Measured pressure LP"
• "Level" measuring mode, Lin. mode "Linear": "Measured pressure HP"
• "Level" measuring mode, Lin. mode "Activate table": "Measured pressure HP"
Display Depending on the selected measuring mode, the following measured values can be
displayed:
Measured value Measuring mode
Measured differential pressure Level, pressure
Corrected pressure Level, pressure
Measured pressure HP Level, pressure
Sensor press. HP Level, pressure
Sensor temperature HP Level, pressure
Measured pressure LP Level, pressure
Sensor press. LP Level, pressure
Sensor temperature LP Level, pressure
Level before linearization Level
Tank content Level
Process density Level
Temperature of electronics Level, pressure
Third Value (152)
Navigation Expert → Communication → HART output → Third Value (152)
Write permission No write permissions. Parameter is read only.
Description The third value is displayed.
4th Value Is (153)
Navigation Expert → Communication → HART output → 4th Value Is (153)
Write permission No write permissions. Parameter is read only.
Description Indicates which measured value is transmitted via the HART protocol as the fourth process
value. The process value is configured via HART command 51.
To Next Page
Loading...
