Endress+Hauser Deltabar FMD72 - Overview of the Operating Menu

Overview of the operating menu Deltabar FMD71, FMD72
16
4 Overview of the operating menu
The following table lists all parameters the "Expert" menu may contain. The page
number refers to where a description of the parameter can be found.
Depending on the parameter configuration, not all submenus and parameters are
available. Information on this can be found in the parameter description under
"Prerequisite".
Expert Direct access Description
Direct Access 119 (→  22)
Expert → System Direct access Description
Code definition 023 (→  28)
Lock switch (read only) 120 (→  44)
Operator code 021 (→  27)
Expert → System → Device Information Direct access Description
Cust. tag number 254 (→  58)
Device tag 022 (→  28)
Serial number (read only) 096 (→  39)
Firmware version (read
only)
095 (→  38)
Ext. order code (read only) 097 (→  39)
Order code (read only) 098 (→  39)
ENP version (read only) 099 (→  39)
Electr.serial no (read only) 121 (→  44)
Ser.no.sensor HP (read
only)
122 (→  44)
Ser.no.sensor LP (read only) 274 (→  61)
Expert → System → Display Direct access Description
Language 000 (→  22)
Display mode 001 (→  22)
2nd disp. value 002 (→  22)
3rd disp. value 288 (→  64)
Format 1st value 004 (→  23)
HART input form. 157 (→  55)
Expert → System → Management Direct access Description
Enter reset code 124 (→  45)
Transm. connect. 286 (→  64)
Expert → Measurement Direct access Description
Measuring mode 005/182 (→  23)