Endress+Hauser Deltabar FMD72 - Page 55

Deltabar FMD71, FMD72 Description of device parameters
55
Write permission No write permissions. Parameter is read only.
Description Display of the unit for the HART input value.
Display • Unknown
• mbar, bar
• mmH2O, ftH2O, inH2O
• Pa, hPa, kPa, MPa
• psi
• mmHg, inHg
• Torr
• g/cm
2
, kg/cm
2
• lb/ft
2
• atm
• °C, °F, K, R
Factory setting Unknown
HART Input Form. (157)
Navigation Expert → System → Display → HART Input Form. (157)
Write permission Operators/Service engineers/Expert
Description Number of decimal places of the displayed input value.
Options • x.x
• x.xx
• x.xxx
• x.xxxx
• x.xxxxx
Factory setting x.x
Reset logbook (159)
Navigation Expert → Diagnosis → Reset logbook (159)
Write permission Service engineers/Expert
Description Use this parameter to reset all messages of the parameter "Last diag. code" and the event
logbook "Last diag. 1" to "Last diag. 10".
Options • Cancel
• Confirm
Factory setting Cancel