Endress+Hauser Deltabar FMD72 - Configuring Pressure Measurement

Deltabar FMD71, FMD72 Description of device parameters
61
MAX. MEAS. TEMP. (271)
Navigation Expert → Diagnosis → Sensor LP → Max. Meas.Temp. (271)
Write permission No write permissions. Parameter is read only.
Description Displays the largest temperature measured in the sensor module. You can reset this value
using the "Reset Peakhold (161)" parameter.
LRL sensor (272)
Navigation Expert → Measurement → Sens. Limit LP → LRL Sensor (272)
Write permission No write permissions. Parameter is read only.
Description Displays the lower-range limit of the sensor module.
URL sensor (273)
Navigation Experts → Measurement → Sens. Limit LP → URL Sensor (273)
Write permission No write permissions. Parameter is read only.
Description Displays the upper-range limit of the sensor module.
Sens. Ser. No LP (274)
Navigation Expert → System → Instrument info → Sens. Ser. No LP (274)
Write permission No write permissions. Parameter is read only.
Description Displays the serial number of the sensor module LP (11 alphanumeric characters).
Lo trim measured (275)
Navigation Expert → Measurement → Sensor Trim LP → Lo Trim Measured (275)
Write permission No write permissions. Parameter is read only.
Description Displays the reference pressure present to be accepted for the lower calibration point.