Endress+Hauser Deltapilot M FMB50 - Page 32

Operation Deltapilot M 4...20 mA HART
32 Endress+Hauser
Operating example: Accepting the pressure present
Example: setting position adjustment
6.3.4 Operation via SFX100
See operating instructions.
6.3.5 Operation via FieldCare
See operating instructions.
6.3.6 Locking/unlocking operation
See operating instructions.
6.3.7 Resetting to factory settings (reset)
See operating instructions.
The new value for the upper range value is 50.0 mbar (0.75 psi).
– You exit the edit mode for the parameter with .
– You can get back to the editing mode with  or .
65 .000 mbar
Pos. zero adjust 007 Operation
1  Abort The pressure for position adjustment is present at the device.
Confirm
2 Confirm Use  or  to switch to the "Confirm" option. The active option is
highlighted in black.
 Abort
3Compensation
accepted!
Accept the pressure present as position adjustment with the 
key. The device confirms the adjustment and goes back to the
"Pos. zero adjust" parameter.
4  Abort Exit the edit mode for the parameter with .
Confirm
Set URV 014 Operation