Endress+Hauser Levelflex FMP51 Modbus - Device Commissioning; Initial Device Setup and Language

Levelflex FMP51 Modbus Commissioning
Endress+Hauser 27
• Setup
• Conf. backup disp.
• Envelope curve
• Keylock on
Calling up and closing the context menu
The user is in the operational display.
1. Press  for 2 s.
 The context menu opens.
XXXXXXXXXX
kg/h
50
Setup
Conf.backup disp
Env. curve
Keylock on
A0037872
2. Press  +  simultaneously.
 The context menu is closed and the operational display appears.
Calling up the menu via the context menu
1. Open the context menu.
2. Press  to navigate to the desired menu.
3. Press  to confirm the selection.
 The selected menu opens.
8 Commissioning
8.1 Switching on the device
‣
Switch on the mains voltage (fuse box).
The device is switched on.
8.1.1 Disabling write protection
If the device is write-protected, write protection must first be disabled.
See the Operating Instructions of the device for this purpose:
8.2 Setting the operating language
Factory setting: English or ordered local language