Endress+Hauser Levelflex FMP57 - Page 168

Operating menu Levelflex FMP56, FMP57 FOUNDATION Fieldbus
168 Endress+Hauser
"Probe length correction" wizard
The Probe length correction wizard is only available when operating via the local
display. When operating via an operating tool, all parameters concerning the probe
length correction are located directly in the Probe settings submenu (→  166).
Navigation  Setup → Advanced setup → Probe settings → Prob.length corr
Confirm probe length 
Navigation  Setup → Advanced setup → Probe settings → Prob.length corr → Confirm length
Description →  167
Present probe length 
Navigation  Setup → Advanced setup → Probe settings → Prob.length corr → Pres. length
Description →  166