Endress+Hauser Liquiline CM444 - Post-Installation Check

Liquiline CM442/CM444/CM448 Installation
Endress+Hauser 15
4.2.3 Wall mounting
≥ 340 (13.4)
≥
150 (5.91)
A0012686
 9 Installation clearance in mm (in)
1
3
4
2
A0027798
 10 Wall mounting
1 Wall
2
4 drill holes
1)
3 Mounting plate
4 Screws Ø 6 mm (not part of scope of supply)
1)
The size of the drill holes depends on the wall plugs used. The wall plugs and screws must be provided by the customer.
A0027799
 11 Wall mounting
A0027797
 12 Attach the device and click it into place
1. Place the device on the mounting plate.
2. Slide the device downwards in the guide on the mounting rail until it clicks into place.
4.3 Post-installation check
1. After installation, check the transmitter for damage.
2. Check whether the transmitter is protected against precipitation and direct sunlight
(e.g. by the weather protection cover).