Transmitter parts
8 Endress + Hauser
9 Promag 53, Promass 83 Ethernet: Replacing bus connector, cable, bus print, connection board, cover for connection board, seal
connection board
Procedure same as in chapter 5.
10 Changing of the Mac adress
If the connection board 53, 83 Ethernet has been replaced the Mac address of the Ethernet device changes. The new Mac address on the
connection plate in the connection compartment cover has to be filled in by the customer.
11 Re-assembly
Installation is the reverse of the removal procedure. The following must be noted:
a b c d
A0013306 A0016649 A0013307 A0016653
e f
A0013308 A0012934
To Next Page
Loading...
