Proservo NMS80 Commissioning
Endress+Hauser 47
G Lower phase
H Tank bottom
1 Gauge reference height
2 Empty
3 Datum plate
4 Tank ullage
5 Tank level
6 Tank reference height
7 High stop level
8 Displacer position
9 Standby level
10 Upper interface level
11 Lower interface level
12 Low stop level
13 Dipping reference
14 Mechanical stop
15 Slow hoist zone
16 Distance
17 Reference position
7.3 Initial settings
Depending on NMS8x specification, some of the initial settings described below may not be
required.
7.3.1 Setting the display language
Setting the display language via the display module
1. While in the standard view (), press "E". If required, select Keylock off from the context
menu and press "E" again.
The Language appears.
2. Open the Language and select the display language.
Setting the display language via an operating tool (e.g. FieldCare)
1. Navigate to: Setup → Advanced setup → Display → Language
2. Select the display language.
This setting only affects the language on the display module. To set the language in the
operating tool use the language setting functionality of FieldCare or DeviceCare,
respectively.
7.3.2 Setting the real-time clock
Setting the real-time clock via the display module
1. Navigate to: Setup → Advanced setup → Date / time → Set date
2. Use the following parameters to set the real-time clock to the current date and time:
Year, Month, Day, Hour, Minutes.
To Next Page
Loading...
Need help?
General
