Endress+Hauser RIA15 - Page 13

RIA15 Installation
Endress+Hauser 13
4. Close the cover and tighten the housing screws.
4.3.3
Mounting the optional HART
®
communication resistance module
Panel housing
The HART
®
communication resistance module is available as an accessory, see section
Accessories in the relevant Operating instructions.
A0020785
 5
Mounting the optional HART
®
communication resistance module
1. Unplug the pluggable terminal block.
2.
Plug terminal block into the suitable plug-in position on the HART
®
communication
resistance module.
3.
Plug the HART
®
communication resistance module into the plug-in position on the
housing.
Field housing
The HART
®
communication resistance module is available as an accessory, see section
Accessories in the relevant Operating instructions.