Operation RIA15
28 Endress+Hauser
The device is operated using three operating keys on the front of the housing. The device
setup can be disabled with a 4-digit user code. If the setup is disabled, a padlock symbol
appears on the display when an operating parameter is selected.
A0017716
Enter key; calling up the operating menu, confirming the option/setting parameters in the
operating menu
A0017714
Selecting and setting/changing values in the operating menu; pressing the '-' and '+' keys
simultaneously takes the user back up a menu level. The configured value is not saved.
A0017715
6.1 Operating functions
The operating functions of the process display unit are divided into the following menus. The
individual parameters and settings are described in the "Commissioning" section of the
relevant Operating Instructions.
If the operating menu is disabled by means of a user code, the individual menus and
parameters can be displayed but not changed. To change a parameter, the user code
must be entered. As the display unit can only display digits in the 7-segment display and
not alphanumeric characters, the procedure for number parameters is different to that
for text parameters.
If the operating position contains only numbers as parameters, the operating position is
displayed in the 14-segment display and the configured parameter is displayed in the 7-
segment display. To edit, press the 'E'-button followed by the user code.
If the operating position contains text parameters, only the operating position is initially
displayed in the 14-segment display. If the 'E' button is pressed again, the configured
parameter is displayed in the 14-segment display. To edit, press the '+' button followed
by the user code.
Setup
(SETUP)
Basic device settings
Diagnostics
(DIAG)
Device information, display of error messages
Expert
(EXPRT)
Expert settings for the device setup
The Expert menu is protected from editing by an access code (default 0000).
To Next Page
Loading...
