Safety instructions RIA15
6 Endress+Hauser
1.1.5 Tool symbols
Symbol Meaning
A0011220
Flat blade screwdriver
A0011221
Allen key
A0011222
Open-ended wrench
A0013442
Torx screwdriver
1.2 Registered trademarks
HART
®
Registered trademark of the HART
®
Communication Foundation
2 Safety instructions
2.1 Requirements for the personnel
The personnel must fulfill the following requirements for its tasks:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task
‣
Are authorized by the plant owner/operator
‣
Are familiar with federal/national regulations
‣
Before beginning work, the specialist staff must have read and understood the instructions
in the Operating Instructions and supplementary documentation as well as in the
certificates (depending on the application)
‣
Following instructions and basic conditions
2.2 Designated use
The process display unit displays analog process variables or HART
®
process variables on its
screen.
The device is powered via the 4 to 20 mA current loop and does not require an additional
power supply.
To Next Page
Loading...
