Endress+Hauser RIA15 - HART Protocol Certification

Installation RIA15
14 Endress+Hauser
A0020844
 6
Mounting the optional HART
®
communication resistance module
1. Unplug the pluggable terminal block.
2.
Plug terminal block into the suitable plug-in position on the HART
®
communication
resistance module.
3.
Plug the HART
®
communication resistance module into the plug-in position in the
housing.
4.4 Post-installation check
4.4.1 Display unit in the panel-mount housing
• Is the seal undamaged?
• Are the mounting clips securely fastened on the housing of the device?
• Are the threaded rods properly tightened?
• Is the device located in the center of the panel cutout?
4.4.2 Display unit in the field housing
• Is the seal undamaged?
• Is the housing firmly screwed to the mounting plate?
• Is the mounting bracket firmly secured on the wall/pipe?
• Are the housing screws firmly tightened?