Battery Charger RLD
User's Manual
OWM-AR-D-[] Page 10 of 23
WARNING !
To prevent fire or shock hazard, do not expose the charger to rain or moisture.
Do not use the e charger in presence of flammable gas, because it can generate sparks!
Do not install the charger near flammable materials.
WARNING !
To reduce the risk of fire, the charger must be installed on a floor
of non-combustible material.
If this is not possible, a floor plate of at least 1,6mm steel extended
at least 150mm beyond the charger on all sides must be installed.
CAUTION !
Allow adequate air circulation to prevent internal heat buildup.
Do not place the unit near materials that may block the ventilation slots.
Do not install the unit near heat sources such as radiators or air ducts, or in a place
subject to direct sunlight, excessive dust, mechanical vibration or shock.
CAUTION !
The operations and settings described in this chapter are
fundamental for the good functionality of the charger.
Improper settings can cause severe damage to the charger and the battery!
Before to install the charger:
Check that the charger input voltage (V) is identical to your AC power supply voltage.
Check that the charger max input power (KVA) is available from your AC power supply.
To Next Page
Loading...
