PRECAUTIONS*
Do Not bring any heat or flame source near battery.
1.
USE EDGE OF MODULE
WHEN POSITIONING BATTERY
DO NOT PUSH ON CENTER
TO POSITION BATTERY
Do Not use any lubricant other than EnerSys Pro-Slide or Dow Corning Silicon
Compound #111 to lubricate rails to facilitate sliding of batteries.
2.
Do Not lift any cells by the terminal posts.
3.
Do Not tamper with seal nuts on the cell post.
4.
Do Not remove coating from post or connectors and expose any bare copper.
5.
6.
Do Not allow cell temperature to exceed 110
o
F during charging.
Publication No. US-FL-IOM-002 January 2007 • Subject to revisions without prior notice. E.& O.E.
Do Not clean cell with anything other than water/bicarbonate of soda.
7.
Do Not over torque connections.
8.
Do Not store EnerSys Lead Antimony batteries for over three months without charge –
9.
EnerSys Lead Calcium for over six months without charge, at normal temperatures.
*
These are only a few of the precautions. Please read this manual thoroughly for complete details.
Represented by:
EnerSys EnerSys EMEA
P.O. Box 14145 Brussels, Belgium
Reading, PA 19612-4145 Tel: +32 (0)2 247 94 47
USA EnerSys Asia
Printed in U.S.A
Tel: +1-610-208-1991 Guangdong, China
© 2007 EnerSys. All rights reserved.
+1-800-538-3627 Tel: +86 755 2689 3639
Trademarks and logos are the property
of EnerSys and its affiliates unless
otherwise noted.
www.enersys.com
To Previous Page
Loading...
