ENFORCER SA-027WQ User Manual

ENFORCER 7-Day Timer
SECO-LARM U.S.A., Inc. 7
Programming (Continued)
Setting the Display Contrast
NOTES
• The contrast is represented relatively from 00~09 (default, 00). Continuing to press ENTER after
reaching 09 will start the cycle over at 00.
• The display contrast can also be set at any time by pressing and holding the SEL and ENTER
buttons at the same time. The screen contrast will gradually adjust. If you continue to hold them,
the contrast settings will cycle back to 00 and start over. When it reaches the level that you
desire, release the buttons.
Setting the Day and Time
NOTE: The time is displayed in 24-hour, military format where 1:00 PM is written as 13:00:00.
Press ENTER to see the
following.
Se t ST D Ti m e
>S U N < 1 3 : 1 5 : 1 7
The day will be flashing.
Press ENTER to change.
Press SEL to accept and
move to the
next option and
repeat.
Keep pressing SEL to
cycle
through and correct errors or
to go to the return icon .
Press ENTER at the to
return to the home screen.
Press SEL until
>S e t T i m e <
appears.
Press ENTER to see the
following.
Se t Co n t r a s t
>0 0 <
The
00
will be flashing.
Continue to press ENTER
until the desired contrast is
reached.
When satisfied, press SEL
to move to the return icon.
Se t Co n t r a s t
>0 0 <
Press ENTER at the to
return to the home screen.
Press SEL until
>S e t D i s p l y <
appears.

ENFORCER SA-027WQ Specifications

General

Brand	ENFORCER
Model	SA-027WQ
Category	Timer
Language	English