Engcon DC2 User Manual

3 Operation
3. Operation
Make sure you have read and understood the entire chapter entitled Operation before
beginning the programming sequence.
The constant flow function in DC2 enables certain selected functions to run without
actively operating DC2 controls. When the constant flow function is installed according
to 9000224 Installation Instructions, selected functions can be activated to run without
operating the controls; all that is required is activation of constant flow. Activation/
deactivation of constant flow can be summarized as follows:
1. Programming sequence – specific functions and the specific flows they will have when
constant flow is activated are determined in the programming sequence.
2. Activation sequence – the activation sequence starts constant flow to selected
functions.
3. Deactivation – when constant flow is deactivated, all active functions that were started
in the activation sequence are stopped.
WARNING
If you have any doubts concerning the safety aspects
of your knowledge, the equipment or work, contact
a dealer or engcon Nordic AB. Incorrect installation
affect safety.
WARNING
Beware of moving parts. A lack of awareness may lead
to crush injuries. Risk of personal injury.
WARNING
Never attempt to increase the maximum capacity
of the equipment by modifications not approved by
the supplier. Risk of personal injury and damage to
property.
CAUTION
If constant flow is activated without activating a
function, the tiltrotator or tool may start unexpectedly
without any controls having been moved.
7

Engcon DC2 Specifications

General

Brand	Engcon
Model	DC2
Category	Controller
Language	English