EOC2611P Quick Start Guide
Wireless Access Point & Client Bridge
Quick Start Guide v.1.0
Refer to User’s Manual for complete instructions 1
EOC2611P is a long range outdoor wireless Access Point / Client Bridge that operates seamlessly in the
2.4GHz frequency and provides high bandwidth up to 108Mbps with Turbo G. It features high
transmitted output power and high receivable sensitivity. High output power and high sensitivity can
extend range and coverage to reduce the roaming between Access Points to get a more stable wireless
connection.
EOC2611P supports distance control by 1km to 30km and RSSI indicator which enables the best
transmission and receives signals for traffic communication. This product comes with PoE injector for
building in outdoor environment easily.
To protect your wireless connectivity, it can encrypt all wireless transmissions through 64/128-bit WEP
data encryption and also supports WPA/WPA2. The MAC address filter lets you select exactly which
stations should have access to your network. In addition, the User Isolation function can protect the
private network between client users.
The attractive design, high performance, and array of features make EOC2611P a suitable wireless
solution for your residence or office.
This Guide will assist you in setting up the Access Point as quickly as possible and with the least effort.
IP Address Configuration
The default IP address of the device is
192.168.1.1. In order to log into this device, you
must first configure the TCP/IP settings of your
PC/Notebook.
1. In the control panel, double click Network
Connections and then double click on the
connection of your Network Interface Card
(NIC). You will then see the following
screen.
2. Select Internet Protocol (TCP/IP) and then
click on the Properties button. This will
allow you to configure the TCP/IP settings
of your PC/Notebook.
3. Select Use the following IP Address radio
button and then enter the IP address
(192.168.1.21) and subnet mask
(255.255.255.0). Ensure that the IP address
and subnet mask are on the same subnet as
the device.
4. Click on the OK button to close this
window, and once again to close LAN
properties window.
Logging In
1. T
o configure the device through the
web-browser, enter the IP address of the
Bridge (default: 192.168.1.1) into the
address bar of the web-browser and
press Enter.
2. After connecting to the IP address, the
web-browser will display the login page.
Specify admin as the default User Name
and Password, and then click on the Login
button.
Administration
1. Click on the Administration link under the
Management section. This option allows
you to create a new user name and
password for the device. For security it is
highly recommended for security reasons.
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
To Next Page
Need help?
General
Weight and Dimensions
