Need help?Do you have a question about the EnGenius EOC-2610 and is the answer not in the manual?
General| Wireless Standards | IEEE 802.11b/g |
|---|---|
| Frequency Band | 2.4 GHz |
| Max Data Rate | 54 Mbps |
| Ethernet Ports | 1 |
| Weight | 0.35 kg |
| Operating Temperature | 0°C to 40°C |
| Operating Modes | Access Point, WDS Bridge, WDS AP |
| Security | WEP, WPA, WPA2 |
| Interface | 1 x 10/100 Mbps Ethernet |
| Power over Ethernet | Yes |
| Power Supply | 12V DC |
Instructions on accessing the device's web interface using a browser and credentials.
Details accessing the Access Point mode interface via web browser and default credentials.
Details WEP encryption setup, authentication types, and key configuration.
Configures WPA/WPA2 pre-shared key encryption and passphrase settings.
Sets up WPA/WPA2 encryption using TKIP or AES for enhanced security.
Provides instructions for upgrading the device's firmware via the web browser.
Instructions for accessing the Client Bridge mode interface via web browser and credentials.
Sets up WEP encryption, authentication types, and key details for the client bridge.
Configures WPA/WPA2 security with pre-shared keys for the client bridge.
Guides on upgrading the client bridge device firmware via the web interface.
Instructions for accessing the Client Router mode interface via web browser and credentials.
Configures WAN interface settings for DHCP, Static IP, or PPPoE connection types.
Details configuring the WAN interface using DHCP for automatic IP address assignment.
Configures the WAN interface with a dedicated static IP address provided by the ISP.
Sets up PPPoE connection for DSL services, requiring ISP username and password.
Sets up WEP encryption, authentication types, and key details for the client router.
Guides on upgrading the client router device firmware via the web interface.
To Next Page
