EnGenius M36 - Quick Start Guide Manual

Long Range Mesh Access Point
M36
Quick Start Guide
Physical Setup
Hardware Installation
1. Plug one end of the Ethernet cable into the RJ-45 port on the rear panel of the device and another end into your PC/Notebook.
2. Insert the DC-inlet of the power adapter into the port labeled “DC-IN” and the other end into the power socket on the wall.
This diagram depicts the hardware configuration
PC
Ethernet
M36
AC/DC cable
Power Outlet
Ethernet Port for RJ-45 cable
DC-inlet for Power
Press 1 second
Reset/Reboot
Press 5 seconds
Reset to factory default
-1-