ENGIE EPS easyWallbox - Charging Process; LED Status Indicators

GB
GB
38
39
2
1
6. CHARGING PROCEDURE
Once installation is completed, recharging an electric vehicle with
easyWallbox is very easy. All you have to do is:
1. Ensure that easyWallbox is connected to an active power supply
2. Check if the LED status indicator is BLUE.
3. Extract the connector from easyWallbox
4. Insert the connector into the electric vehicle
6.1. LED status indicator
There is a strip of LEDs on the front of the charging station which
combines visual signals and alarms indicating the status of
e as yW allbo x :
⚫ BLUE STAND-BY status,
easyWallbox indicates it is ready to start the charging process or
charging session is complete.
⚫ GREEN RECHARGING status,
easyWallbox is recharging the electrical vehicle.
⚫ FLASHING RED ALARM status,
easyWallbox is not charging due to an error.
easyWallbox self-restores from minor errors within a few seconds.
If it remains in ALARM status for a long time, please contact
assistance as explained in 11.
For information on completion of charging, please continue to 7.
- Vehicle adaptors should not be used to connect a vehicle
connector to a vehicle inlet
- Avoid dynamic stress of the cable. Do not pull or twist it.