3.5.
Product versions country by country
easyWallbox is designed to provide up to 7.4 kW of charging power
in Mode 3 or Mode 2 with Power Upgrade. However,
the maximum
power
depen
ds
on
differ
ent
f
a
c
t
or
s
,
in
c
ludin
g
local
r
egulations
f
or
suc
h
a
device.
The settings for easyWallbox maximum power should only be made by
qualified personnel who follow this manual carefully in compliance with
local regulations, international standards and any constraints on the
existing domestic electrical system.
4.
INSTALLATION
4.1.
Choice of position
easyWallbox is only for fixed wall mounting, and therefore cannot be
used in different spaces where its continual movement is required.
Before installing the device, check the feasibility. In detail, the position
chosen for the installation of easyWallbox must:
⚫ be on a vertical and flat surface, as shown in 4.5; weak surfaces that
do not ensure robust resistance must be avoided
⚫ allow easy connection to the power supply and the electric vehicle to
charge
⚫ not be an obstacle to the movement of the electric vehicles to charge
⚫ not have material or equipment on the whole of the surface required
for the installation
⚫ respect local legislation on electrical installations, fire prevention
measures and rescue methods in the installation site
easyWallbox
must not be installed in places:
⚫ at risk of explosion (EX environment)
⚫ used for escape routes
⚫ where articles may fall on it (e.g. suspended ladders or car tyres) or
where it is likely to be hit and damaged (e.g. close to a door or in
vehicle operating spaces)
⚫ where there is a risk of pressurised jets of water (e.g. because of
washing systems, power washers or garden hoses)
Go to paragraph 4.1 Go to paragraph 4.6
To Next Page
Loading...
