ENGIE EPS easyWallbox - Maintenance Guidelines

GB
GB
42
43
Before carrying out any type of maintenance on easyWallbox, wait
for it to come to a complete halt and turn it off, disconnecting it
from the power supply.
8. MAINTENANCE
The perfect operation and duration of easyWallbox depends on periodic
checks and maintenance made on the device.
Here ar e some e x amples of damage that e as yW allbo x ma y suffer :
⚫ damage to the case
⚫ damage to the front panel
⚫ damage to components
⚫ accidental removal of components
8.1. Ordinary maintenance Intervals
easyWallbox does not require specific maintenance. However, it is
recommended to:
⚫ always insert the connector into easyWallbox when the device is not
in operation
⚫ we advise regular cleaning of the plastic case with a damp cloth
⚫ we advise a regular inspection and cleaning of the connector only
after removing the power supply
⚫ avoid cleaning with aggressive solvents or abrasive materials
⚫ carry out a visual inspection of the device to note defects at every
charging session
⚫ carry out a visual inspection on the recharging cable at every
charging session
⚫ carry out a visual inspection on the power supply cable at every
charging session and, however, before any connection to the power
supply
⚫ If the power supply plug is removed from the socket, please place
the cable tidily, if necessary by rolling it around the case of
e as yW allbo x . An yh o w , th e cable must be pla c ed in a saf e mann er ,
where it does not obstruct anyone and cannot be damaged
(e.g. pressed by vehicles)
⚫ control of operational readiness
If the device is damaged, follow the instructions below precisely to avoid
dangerous situations, with the resulting damage to persons or things:
⚫ avoid using the damaged device
⚫ clearly indicate the damaged device so that other people will not use it
⚫ call qualified personnel promptly so that the device can be repaired
or, if irreparably damaged, taken out of service
A defective or damaged device must not be used under any
circumstances. Any defects must be rectified immediately by
qualified personnel.
The only part that can be removed from easyWallbox is the
aesthetic cover, only during the installation and dismantling phases
and following the instructions. easyWallbox should not be opened
further unless by qualified personnel while performing installation
in Mode 3, dismantling or maintenance
easyWallbox does not contain components that the user can
repair or maintain autonomously.
Danger of electric shock when the device is damaged. Use of a
damaged device may generate electrical discharges.